Product Code: APC-LD1-24VAC/DC
Single Channel Loop Detector
|
|
Usage of Loop Detector:
The APC-LD1 is a loop detector sensor module that is used wherever vehicles need to be detected. The loop detector can be connected to any of the following types of systems that allow the use of a loop detector:
- Driveway Gate Mechanisms
- Operating Barrier Mechanisms
- Traffic Light Systems in car parks
How it Works:
The loop detector is housed in the controller box/enclosure of the connected mechanism and is used to communicate with the underground inductive loop wire when a vehicle is detected which then sends a signal to the connected system to open the mechanism, close the mechanism or prevent the system from closing.
|
|
|
|
Specifications
|
|
Voltage: |
24V AC/DC |
Voltage Tollerance AC: |
+10% / -15% |
Voltage Tollerance DC: |
+/- 15% |
Power Consumption: |
4.5VA |
Output Relays: |
240V/5A |
Frequency Range: |
20 kHz to 170 kHz |
Reaction Time: |
10ms |
Signal Holding Time: |
Unlimited, Limited when loop is permanently covered |
Sensitivity: |
Adjustable in 4 increments |
Wiring: |
Recommend 100μH to 300μH |
Operating Temperature: |
-20°C to +65°C |
Storage Temperature: |
-40°C to +85°C |
|
|
Typical Loop Layout Diagram 1
|
|
|
|
Typical Loop Layout Diagram 2
|
|
|
|
Typical Loop Wiring Measurements
|
|
|
|
Approximate Loop Sizes |
|
|
Driveway Width
|
Loop Size
|
3m - 4.5m |
1.8m x 1.2m |
4.8m - 5.4m |
2.4m x 1.2m |
5.8m - 6.7m |
3m x 1.2m |
7m - 7.9m |
4.3 x 1.2m |
|
|
Loop Wiring Diagram
|
|
|
|
|
|